Centre Design Option: Stylus Runway Diamond Selected Part: - none - Talon FS - Line Art Customer Information: Name Delivery Address (NOT a PO Box) PH (Work) PH (Home) PH (Mobile) Email Reserve Top Flap (1) Centre Flap (2) Main Side/Bottom (3) Main Side Flaps (4) Reserve Side Flaps (5) Main Riser Covers (6) Monogram Flaps (7) Leg Pads (8) Main Pin Cover (9) Trim (Around panels) Centre Flap (2) Design Stripe Colour A Stripe Colour B Stripe Colour C Pin Stripe Piping Colour - Between Stripes (2) Pin Stripe Piping Colour - Side Profile (3) Harness/Riser Colour Harness Style Multi-Flex FAST (Rings at hip junction only) Release Handle Colour Red Other: RSL Required Reserve Ripcord Standard D Low Profile D Soft Pad Pilot Chute BOC Handle Ball Handle: Soft Pad: Embroidery Monogram (7) Embroidery Monogram (7) - Lettering Style Colour: Block Script Talon FS Logo Embroidered down each side (3) Yes No Talon FS Logo Colour Talon: FS: Is an AAD to be installed into the system? No Yes, type: Supply AAD Reserve Canopy Size and Type Supply Reserve Main Canopy Size and Type Supply Main Customer Measurements: Help Instructions 1. Height Standing on a hard surface, with bare feet, measure from floor to top of head. 2. Inseam With bare feet, shoulder width apart, measure from crotch to floor along the inside of the leg. 3. Waist Measure the circumference over the navel, around the waist, parallel to the floor. 4. Thigh Measure at the highest part of the thigh, parallel to the floor (Do not try to duplicate any harness angle) Ensure that pockets are empty. 5. Chest Measure the circumference of the chest at the widest part, relaxed, with hands at sides. 6. Hip Measure the circumference around the widest part of the hips. Make sure that all pants pockets are empty. 1. Height cm 2. Inseam cm 3. Waist cm 4. Thigh cm 5. Chest cm 6. Hip cm Weight kg Sex Male Female Notes Send Design to Parachutes Australia